HELP!! CAN'T GET OUT OF MY COMMUNITY

Message

Apitoxin · #11 Post by **Apitoxin** » Mon Jun 19, 2006 12:08 am

Yeah, you can put a magnet on the bottom of your bike. Or you can glue your valves in place. They work just as well as eachother.

Brent · #12 Post by **Brent** » Mon Jun 19, 2006 4:20 am

Do you ever have anything positive to say???

scharley · #13 Post by **scharley** » Mon Jun 19, 2006 9:23 am

put kickstand down in middle of pad lean on side stand. works every time

flynrider · #14 Post by **flynrider** » Mon Jun 19, 2006 10:08 am

Tell the homowners' association to tweak the loop sensor so it will detect motorcycles. This is fairly easy to do. I ride my bike through several types of security gates with loop sensors and they can all detect it.

Brent · #15 Post by **Brent** » Mon Jun 19, 2006 10:25 am

I haven't tried the kick stand down thing. I can do that course gotta put it in neutral first cause bike will die. And I do have an E-Mail out to the Community about it.

Sev · #16 Post by **Sev** » Mon Jun 19, 2006 10:26 am

Brent wrote:I haven't tried the kick stand down thing. I can do that course gotta put it in neutral first cause bike will die. And I do have an E-Mail out to the Community about it.

I tried that last night, and as soon as the kickstand hit the ground the "walk safely light" went off and the light started to change. I don't know if it was related, or not.

snwbrdr · #17 Post by **snwbrdr** » Mon Jun 19, 2006 1:17 pm

The kickstand only works sometimes. i have a two lights i can only trigger with my stand, but the stand doesnt work at a few others i know of.