Page 2 of 2
Posted: Mon Jun 19, 2006 12:08 am
by Apitoxin
Yeah, you can put a magnet on the bottom of your bike. Or you can glue your valves in place. They work just as well as eachother.
Posted: Mon Jun 19, 2006 4:20 am
by Brent
Do you ever have anything positive to say???
Posted: Mon Jun 19, 2006 9:23 am
by scharley
put kickstand down in middle of pad lean on side stand. works every time
Posted: Mon Jun 19, 2006 10:08 am
by flynrider
Tell the homowners' association to tweak the loop sensor so it will detect motorcycles. This is fairly easy to do. I ride my bike through several types of security gates with loop sensors and they can all detect it.
Posted: Mon Jun 19, 2006 10:25 am
by Brent
I haven't tried the kick stand down thing. I can do that course gotta put it in neutral first cause bike will die. And I do have an E-Mail out to the Community about it.
Posted: Mon Jun 19, 2006 10:26 am
by Sev
Brent wrote:I haven't tried the kick stand down thing. I can do that course gotta put it in neutral first cause bike will die. And I do have an E-Mail out to the Community about it.
I tried that last night, and as soon as the kickstand hit the ground the "walk safely light" went off and the light started to change. I don't know if it was related, or not.
Posted: Mon Jun 19, 2006 1:17 pm
by snwbrdr
The kickstand only works sometimes. i have a two lights i can only trigger with my stand, but the stand doesnt work at a few others i know of.