Page 1 of 1

Battery died from lack of use.

Posted: Sun Apr 09, 2006 7:51 pm
by 1walther40
I have a 6 amp charger. Do I need to remove cables from battery to recharge? Or do I leave everything in place? How long will a recharge take?
Thanks

Posted: Sun Apr 09, 2006 8:35 pm
by BuzZz
You shouldn't need to pull the cables off the battery first to recharge, unless there is a short or some other power draw issue.

How long it takes depends on the condition of the battery and how low it is. If you can leave it charge on a 2 amp setting for a few hours, that's good. If you can only dump 6 amps, keep an eye on it so it don't boil after an hour or so. Then test it and see if it's good or needs to go longer.

Battery

Posted: Sun Apr 09, 2006 8:57 pm
by 1walther40
Thanks, the charger is a old and primitive one. The only setting it has is 6 vs 12 volt. I hooked it up an let it sit for about 4 hours. When I disconnected there was a bubbling noise at the battery. Is the boil you were referring to?
Thanks and good morning.

Posted: Sun Apr 09, 2006 10:22 pm
by BuzZz
Sounds about done and ready to serve.

Go for a ride. :wink:

Posted: Sun Apr 16, 2006 11:17 am
by MotoF150
NO NO NO !!!!! DO NOT USE 6 AMPS TO CHARGE A MOTORCYCLE BATTERY !!!! charge the battery no more than 2 amps!