Total Motorcycle Community Forums

So far so good with the installation of Plex. 3, but the instructions appear
to be messed up at step #5 where it says to install the Pivot Mounts
snuggly . . . then at stop #9 it says "IMPORTANT" to place Tape under
Pivot Mount..well the Pivot Mounts were put on way back at step #5,
so I guess I have to take off my Pivot Mounts and put the tape under
them (between to bar and the Pivot Mount) and start over with installing
the Pivot Mounts ? ?

Is the tape necessary to be between the Pivot Mounts and the bar?

It's probably to increase friction, and at the same time prevent it from sliding around.

i have 3 plexifairing 3 shields now and have had about 6 others over the years.i have never used the tape.