Chain Oil vs Wax
- flw
- Site Supporter - Silver
- Posts: 899
- Joined: Fri Jul 07, 2006 4:16 pm
- Sex: Male
- Years Riding: 8
- My Motorcycle: '98 Honda Goldwing GL1500se
- Location: Rockford, Illinois U.S.
Chain Oil vs Wax
I never used chain wax. Is it better and if so, in what way?
Also how do you apply the wax as compared to oil?
Also how do you apply the wax as compared to oil?
Goldwing 1500se '98
VN500 LTD '07 Sold
VN500 LTD '07 Sold
- Dragonhawk
- Legendary 500
- Posts: 501
- Joined: Fri Dec 30, 2005 12:30 am
- Sex: Male
- Location: Los Angeles
Don't use oil. That stuff gets EVERYWHERE. Even when you wipe off the excess, it makes a freakin' mess. If you REALLY want to use oil, use a heavyweight gear oil like 80W-140 or something. Heavier the better. It sticks better and is less-likey to fly-off ... of course, when it DOES fly-off, it isn't easy to clean up.
Instead, use nice spray-on chainlube like PJ1 Blue Label or something similar. It still protects and lubes the chain and isn't nearly as messy.
I speak from experience. Getting oil-stains off silver mags is not fun and not easy without harsh chemicals ... or Los Angeles tap water (which actually worked better, creepily enough...)
Instead, use nice spray-on chainlube like PJ1 Blue Label or something similar. It still protects and lubes the chain and isn't nearly as messy.
I speak from experience. Getting oil-stains off silver mags is not fun and not easy without harsh chemicals ... or Los Angeles tap water (which actually worked better, creepily enough...)
[b]Are you a beginner rider?
Have a lot of questions about motorcycling?
Not sure what bike to start with?
[url=http://www.wyndfeather.com/learn/motorcycle.htm]Learn To Ride A Motorcycle - A Step-By-Step Guide[/url][/b]
Have a lot of questions about motorcycling?
Not sure what bike to start with?
[url=http://www.wyndfeather.com/learn/motorcycle.htm]Learn To Ride A Motorcycle - A Step-By-Step Guide[/url][/b]
The chain wax seals the chain keeping dirt from entering and keeping the lube inside the chain, and if you have an "O" or "X" ring chain using the wrong oil or lube may do harm to the O or X rings and its very important to check and adjust the correct tension of the chain everytime you take ur bike out for a ride. I know a good brand of Chain Wax that will work on any chain but I will decline to type the brand name of this product cause I don't want other people of this board calling me names and telling me im giving out wrong information. When you shop for chain wax, read the lable.
2011 Toyota Tacoma 4x4, 09 Yamaha Tmax, 08 Suzuki King Quad 750
- Sev
- Site Supporter - Gold
- Posts: 7352
- Joined: Sun Jun 06, 2004 7:52 pm
- Sex: Male
- Location: Sherwood Park, Alberta
If your chain has tension you're going to destroy your transmission.MotoF150 wrote:its very important to check and adjust the correct tension of the chain everytime you take ur bike out for a ride.
Of course I'm generalizing from a single example here, but everyone does that. At least I do.
[url=http://sirac-sev.blogspot.com/][img]http://i12.photobucket.com/albums/a227/Sevulturus/sig.jpg[/img][/url]
[url=http://sirac-sev.blogspot.com/][img]http://i12.photobucket.com/albums/a227/Sevulturus/sig.jpg[/img][/url]
- flw
- Site Supporter - Silver
- Posts: 899
- Joined: Fri Jul 07, 2006 4:16 pm
- Sex: Male
- Years Riding: 8
- My Motorcycle: '98 Honda Goldwing GL1500se
- Location: Rockford, Illinois U.S.
That was always my understanding. Greater than 1/4 to 3/8 inch. 1/2 inch is abit too much on average. This is the deflection of the chain with finger pushing on it upwards from bottom. The range is because there is no truely accurate way to measure this.Sev wrote:If your chain has tension you're going to destroy your transmission.MotoF150 wrote:its very important to check and adjust the correct tension of the chain everytime you take ur bike out for a ride.
Goldwing 1500se '98
VN500 LTD '07 Sold
VN500 LTD '07 Sold
- Sev
- Site Supporter - Gold
- Posts: 7352
- Joined: Sun Jun 06, 2004 7:52 pm
- Sex: Male
- Location: Sherwood Park, Alberta
Just giving Moto a hard time because he's so smart. A belt has tension, a chain has slack. If you've got your chain under tension it's way to tight and is pulling the countershaft sprocket towards the rear of the bike. This puts some twisting side load on the countershaft which presses oddly against the mainshaft and can basically cause your transmission to shred itself.flw wrote:That was always my understanding. Greater than 1/4 to 3/8 inch. 1/2 inch is abit too much on average. This is the deflection of the chain with finger pushing on it upwards from bottom. The range is because there is no truely accurate way to measure this.Sev wrote:If your chain has tension you're going to destroy your transmission.MotoF150 wrote:its very important to check and adjust the correct tension of the chain everytime you take ur bike out for a ride.
Basically with your bike fully loaded and you sitting on it with a full tank of gas and everything you want to have about 1/4" of freeplay left in the chain. But that's bloody tough to check by yourself. And don't do it with the bike running.
Of course I'm generalizing from a single example here, but everyone does that. At least I do.
[url=http://sirac-sev.blogspot.com/][img]http://i12.photobucket.com/albums/a227/Sevulturus/sig.jpg[/img][/url]
[url=http://sirac-sev.blogspot.com/][img]http://i12.photobucket.com/albums/a227/Sevulturus/sig.jpg[/img][/url]
Check out Bel-Ray SuperClean Lube.
This stuff is great.. long lasting, and it does not fling up everywhere!
http://www.mxdeals.com/lube-chain-clean ... y-bel.html
This stuff is great.. long lasting, and it does not fling up everywhere!
http://www.mxdeals.com/lube-chain-clean ... y-bel.html
2003 Honda Shadow ACE Deluxe
- jstark47
- Site Supporter - Silver
- Posts: 3538
- Joined: Fri Feb 03, 2006 2:58 pm
- Sex: Male
- Years Riding: 16
- My Motorcycle: '12 Tiger 800, '03 Trophy 1200
- Location: Lumberton, NJ
+1. A little bit too loose with the chain is nowhere near as bad as a little bit too tight.Sev wrote:If you've got your chain under tension it's way to tight and is pulling the countershaft sprocket towards the rear of the bike. This puts some twisting side load on the countershaft which presses oddly against the mainshaft and can basically cause your transmission to shred itself.
Basically with your bike fully loaded and you sitting on it with a full tank of gas and everything you want to have about 1/4" of freeplay left in the chain. But that's bloody tough to check by yourself. And don't do it with the bike running.
2003 Triumph Trophy 1200
2009 BMW F650GS (wife's)
2012 Triumph Tiger 800
2018 Yamaha XT250 (wife's)
2013 Kawasaki KLX250S
2009 BMW F650GS (wife's)
2012 Triumph Tiger 800
2018 Yamaha XT250 (wife's)
2013 Kawasaki KLX250S