Page 1 of 1
VTR250 torque values?
Posted: Wed Mar 21, 2007 6:30 pm
by Gadjet
Quick question for those that might know
What are the proper torque values for the front axle/pinch bolts for a 1990 Honda VTR250?
The GF's ex took the front wheel off to get the tire replaced yesterday, and they have no manual for the bike to say what the bolts should be torqued to when reassembling.
Posted: Thu Mar 22, 2007 2:51 am
by Sev
The last bike about that size that I worked on was 30 for the axle and 13 for the pinch bolts. What size are the bolts?
Posted: Thu Mar 22, 2007 5:06 am
by Johnj
Go get a manual.
Posted: Thu Mar 22, 2007 1:26 pm
by Gadjet
Sev wrote:The last bike about that size that I worked on was 30 for the axle and 13 for the pinch bolts. What size are the bolts?
The bolts look to be M6(?) I didn't get a close look at it last night - I was more concerned about the Red Green brace job that Merlyn used to hold the bike up so he could take the wheel off.
I just love having friends who decide to work on their bikes without benefit of proper tools or the like. (Laura at least knows to bring her bike to me to get any work done on it, Merlyn is another story entirely)
Posted: Fri Mar 23, 2007 3:41 am
by Big B
for some goofy-assed reason my all makes cd lists an xr250r, but no vtr 250 (if it's the same bike then we're in business) the front wheel spindle nut is 58 ft/lbs and the spindle clamp nut at 10 ft/lbs
Posted: Fri Mar 23, 2007 10:29 am
by Shorts
Posted: Fri Mar 23, 2007 11:19 am
by Big B
ahhh, well done. i knew this program was worthless
Posted: Fri Mar 23, 2007 12:39 pm
by Gadjet
thanks Shorts. I'll pass on the info.
I really hope Merlyn enjoys trying to torque the bolts back in place with his brand new, el-cheapo beam type torque wrench.
(can you tell I have little faith in his maintenance skills?)
