Need Crash bars for Vulcan 500

Message

flw · #1 Unread post by **flw** » Sun Mar 25, 2007 4:56 am

I'm looking for crash bar/engine bar for Vulcan 500/EN500. I've looked through JC Whitney and others with no luck.

Anyone have some suggestons? I know that options for the EN500 are few but I really want a set for my own peace of mind that I can bolt on myself.

Sev · #2 Unread post by **Sev** » Sun Mar 25, 2007 5:22 am

If you cannot find anything it might be possible to have some made up?

http://www.accessoryinternational.com/engineguards.htm

This site has a set called the: WINGERLINE HIGHWAYBARS
almost at the very bottom of the page that says it will fit your bike...

niterider · #3 Unread post by **niterider** » Sun Mar 25, 2007 5:31 am

Here are some links that I was refurred to.
bing.com
meancycles.com
cruisercustomizing.com
this may help.

NorthernPete · Sun Mar 25, 2007 7:12 am

I have found that accessories for the 500 are quite difficult to locate. Just not much of a market for them I guess is their mindset. If you do happen to find some good sites, send me a PM with the details, as Id be interested as well. this may help you as well. http://autos.groups.yahoo.com/group/EN500/

flw · #5 Unread post by **flw** » Sun Mar 25, 2007 10:19 am

Sev wrote:If you cannot find anything it might be possible to have some made up?

http://www.accessoryinternational.com/engineguards.htm

This site has a set called the: WINGERLINE HIGHWAYBARS
almost at the very bottom of the page that says it will fit your bike...

I checked all the sites above and this is the only one that had crashbars for my bike. Thank you very much. I just hope the quality to assemble them with typical hand tools is enough. I just don't have the drills and taps for any of that kind of work.