Page 1 of 2
info on SACS
Posted: Tue Dec 09, 2008 9:34 am
by twanne
i'm working n a project and looking urgently fo some technical info on the suzuki advanced cooling system.
Can someone help me?
Posted: Tue Dec 09, 2008 11:17 am
by Wrider
http://en.wikipedia.org/wiki/Suzuki_Adv ... ing_System
That should help! If there's anything else I'm starting my last three weeks of Suzuki next Monday and I can ask the instructors in there!
Wrider
Posted: Wed Dec 10, 2008 7:36 am
by twanne
Thanks a lot for the quick reply.
The info I would need would be in fact an oil flow chart, or more of a technical kind of data. You see what I mean. There is a lot of info on the site, but no technical stuff to analyse.
Do you have acces to this kind of data to?
Greetings from Belgium, Antoon
Posted: Wed Dec 10, 2008 9:50 am
by Wrider
Hmmm... Well I know where a chart is but it's on the wall in the Suzuki room... Let me see if I can find one for you.
Wrider
Posted: Mon Dec 15, 2008 10:20 am
by twanne
still no answer on the SACS-problem?
greetings,
Antoon Boeykens
Posted: Mon Dec 15, 2008 12:43 pm
by Wrider
Honestly haven't really been able to find much on it. As a suggestion the Bandit 1200 used the same basic engine design as a GSXR1100 or 1000 clear up to 2007, which used the SACS system.
Wrider
Re: info on SACS
Posted: Fri Dec 26, 2008 8:53 pm
by crazypj
twanne wrote:i'm working n a project and looking urgently fo some technical info on the suzuki advanced cooling system.
Can someone help me?
What do you want to know?
general information has been posted and the wikki link is OK.
It uses two oil pumps, one for lubrication and one for cooling.
The oil jet spraying onto underside of piston is still in use (by everyone)
It works well up to about 160 hp, more if your only doing short trips ( drag racing)
developed from 1930~40's piston engined aircraft engines but was first motorcycle application
PJ
Posted: Sat Dec 27, 2008 7:21 am
by twanne
The info I got is fine, but my professor read my work and asked whether I could find some more detailed (technical) info on the subject. This kind of info is generally not available on the internet though...
I am talking about technical drawings and stuff. Anyway, thanks a lot you guys!
Antoon
Posted: Sat Dec 27, 2008 7:22 am
by Wrider
I was able to send him the oil section of the service manual for the GSF1200, and he said that's what he needed, didn't really close out the thread, but yeah, got it taken care of.
Wrider
EDIT:
Oops... Hmm, honestly I can't really find anything else on that. I know where a poster is but that's about it.
Sorry bud, wish I could help more!
Posted: Sat Dec 27, 2008 9:31 pm
by crazypj
I don't have a motor stripped down but I do have a spare cylinder head I could take pictures of if you still need them?
I may have picture of the oil flow paths somewhere as well.
Wasn't there a picture of SACS oil flow in old FAST notes?
Did you try Maximum Suzuki and Katriders?
PJ