Syncing with homebrew carb gauge
Posted: Wed Jun 08, 2005 1:47 pm
Hi,
Im syncing my carbs with a homebrew carb gauge ... clear tubing and oil. Now I can sync the carbs just fine on idle... I can bring it to within 4 cm of oil level. But the problem is that when I rev up the engine, the oil level sits steady for sometime and then suddenly starts to rise up in the direction of one carb.
Are my carbs falling out of sync? the direction of oil level change is consistent towards the left carb, Im just not sure if the low density of the oil instead of mercury makes any difference... and whether the gauge can be easily destabilized, even if there is a momentary vacuum difference between the carbs.
thanks
-Kartik
Im syncing my carbs with a homebrew carb gauge ... clear tubing and oil. Now I can sync the carbs just fine on idle... I can bring it to within 4 cm of oil level. But the problem is that when I rev up the engine, the oil level sits steady for sometime and then suddenly starts to rise up in the direction of one carb.
Are my carbs falling out of sync? the direction of oil level change is consistent towards the left carb, Im just not sure if the low density of the oil instead of mercury makes any difference... and whether the gauge can be easily destabilized, even if there is a momentary vacuum difference between the carbs.
thanks
-Kartik