Page 1 of 1
clutch on 1200 harley sportster too tight and wondering
Posted: Sat May 16, 2009 1:34 pm
by jgypsy
i just got this bike and the clutch is so hard to pull in.i was wondering if there is a adjustment to fix this problem.my hands are small.another issuse is the fact its a liittle to tall.im 5'3.im wondering what could be done without lowering the bike.and if i have to lower it,will be make for a rougher ride.i guess i really dont care it its alittle rougher if i can put my feet firmly on the ground at a stop.thanks in advance for any helpim trying to get ready to ride it while im riding a 250 pagsta.
Posted: Sat May 16, 2009 1:37 pm
by siralienj
Did you buy an XL1200L or a Custom? They can lower it with lowering shocks but the 1200L comes prelowered.
I'd call your HD dealer. Maybe they can adjust the clutch a bit. Eventually though your hand will build up strength and you won't notice it anymore.
Posted: Sat May 16, 2009 3:01 pm
by HD1200C
Is it brand new? If so,it should loosen up with time and as you break it in. Or you could take it to the nearest shop.
As far as it being too tall...those are the kinds of things you should check out before you buy. Though, there are ways to lower, just talk to your local dealer is my advice.
details on bike
Posted: Sat May 16, 2009 3:15 pm
by jgypsy
its a 1996 xl1200c with 9500 miles on it.the clutch on it is tighter than my bfs 2008 twin v 2000 cow.
Posted: Sat May 16, 2009 3:44 pm
by HD1200C
In that case I would just take it to your local bike shop/dealer. Usually though with time you'll get used to it and it will feel easier to pull in...but if it is really that tight just take it to the shop.
Good luck and have fun!
Posted: Sun May 17, 2009 3:29 pm
by koji52
You can definately have the dealer adjust your clutch a bit...
If you want more specific advice on the xl, check out xlforum.net ... there's a wealth of knowledge over there