Total Motorcycle Community Forums

Posted: **Fri Jun 22, 2012 1:05 pm**

am changing the ignition modual in my 96 ural,the new unit has three wires,two red and one black,am I right in assuming that one red goes to one side of the coil,the other red to in coming power and the black to the other side of the coil,if so does the blck wire need a jumper to the case as ground?
thanks ,any help appreciated

Posted: **Fri Jun 22, 2012 1:38 pm**

Welcome to the forums Riverdriver! I just changed the topic of your post to get you even more help.

Best of luck, I am sure you will get an answer in no time.

Mike

Posted: **Fri Jun 22, 2012 3:15 pm**

Where's the king of Ural when you need him... GUMMIENTE where are you???

Total Motorcycle Community Forums

help needed: changing the ignition modual in my 96 ural

help needed: changing the ignition modual in my 96 ural

Re: help needed: changing the ignition modual in my 96 ural

Re: help needed: changing the ignition modual in my 96 ural