Total Motorcycle Community Forums

Hi Riders,
I have been riding bikes for over 20 years, I have recently come across an 82 Honda CB900C, I am in the process of making a bobber. I am having Clutch problems, the Push Rod will not move. I can tell that someone has tried to do some work on it because the screws were loose on the case and the seal was new. When I pull in the clutch it does not move the push rod. I have checked the Cable and that is not the issue. Does anyone have any ideas?
Thanks
Rford

Chances are that the pushrod itself is seized into the housing.

I don't know that specific bike, but if you can, get on the back side of it and use some compressed air/hydraulic pressure to break it loose.

I will try that, and let you know how it goes, It will be a few days before I can work on the bike again.

Thanks.

The Clutch problem is solved, thats for all the help, you guys are great, on to the next step, fixing the seal on my front folks.

Forks,

sorry,

lol

...and Reford, can you share how you solved/fixed it for others here?

Mike

That'd be very helpful! And no problem.