Page 1 of 1

96 zx11 issue

Posted: Sat May 18, 2013 12:21 pm
by zx11
I have a 96 zx-11. At first it had a idle issue, it will not stay crank without using the choke. I replaced the jets, now it idles good after it warms up, but it cuts off when I give it some throttle. This is when it is still in neutral, I still have it apart but in a condition were it will still crank, so I haven't tried to put it in gear yet. Can anyone help me with this issue?

Re: 96 zx11 issue

Posted: Sat May 18, 2013 7:21 pm
by Wrider
Have you balanced the carbs? If not that's where to start.
Have you adjusted the fuel/air screws? They should be around 2.5 turns out.

Re: 96 zx11 issue

Posted: Sat May 18, 2013 7:43 pm
by zx11
This was my first time doing carbs, but all I did was change the jets. I did search YouTube for the syncing steps, but it doesn't make sense to me. The fuel/air screw, is it 2.5 from where it sits already?

Re: 96 zx11 issue

Posted: Sat May 18, 2013 7:48 pm
by Wrider
For the fuel/air screw, screw it all the way in so it LIGHTLY touches down. Then screw it out 2.5 turns.

For the synching, you either need to build or buy a manometer. The synching process is actually pretty simple. Where are you at? We might have a member willing to stop by and help you out with it.

Re: 96 zx11 issue

Posted: Sat May 18, 2013 8:03 pm
by zx11
Fayetteville NC. I will adjust the screw tomorrow. Thanks

Re: 96 zx11 issue

Posted: Sat May 18, 2013 8:41 pm
by Wrider
Just remember there's one on each carb.

I do know a guy out near Dunn. I'll see if he's up for helping out.