Page 1 of 2

spuddering and popping

Posted: Sun Jun 23, 2013 6:11 am
by jakee1
:? spuddering and popping when giving throttle, have already cleaned carbs and checked boots can anyone give me some advice on what to check next. :frusty:

Re: spuddering and popping

Posted: Sun Jun 23, 2013 2:13 pm
by Johnj
Well I guess you could check your coils, plug wires,and plugs. Have you done anything like cut down the baffles to it?

Re: spuddering and popping

Posted: Sun Jun 23, 2013 11:03 pm
by BRUMBEAR
Stock exhaust? If you changed exhaust did you jet the carbs? Ground issue? Voltage issue?

Re: spuddering and popping

Posted: Sun Jun 30, 2013 4:46 am
by jakee1
havent done anything different it was running fine then all of a sudden it just started running like crap, so i cleaned the carbs bc it had some trash in the tank, didnt make any difference. i also installed a in line filter, after it still didnt help i uninstalled the filter, still no difference.

Re: spuddering and popping

Posted: Sun Jun 30, 2013 4:52 am
by jakee1
i will check for ground issues, and last year i put new coils and the pickup on the crankshaft. also it reved fine a couple of times yesterday then back to the same crud.

Re: spuddering and popping

Posted: Sun Jun 30, 2013 7:17 am
by Johnj
Sounds to me that the carbs are not clean. I know you cleaned them, but did you clean out all the jets and passageway. That happens when there's trash in the tank.

Re: spuddering and popping

Posted: Fri Jul 05, 2013 7:51 am
by jakee1
well i cleaned the carbs again this time really took my time and made sure it was clean and still no change, could a loose timing chain be the problem.

Re: spuddering and popping

Posted: Fri Jul 05, 2013 12:53 pm
by Johnj
Have you got a manual? What does it (the service manual) say to check?

Re: spuddering and popping

Posted: Fri Jul 05, 2013 3:59 pm
by BRUMBEAR
check your plug wires

Re: spuddering and popping

Posted: Mon Jul 08, 2013 11:41 am
by jakee1
i noticed some backfiring back through one carb when trying to rev yesterday. the manual says to check ignition timing, plugs and wires. im thinking i may have a valve sticking, could this be the problem?