Page 1 of 1
Honda CB360 Solenoid
Posted: Thu Jul 27, 2017 1:34 am
by SCCB
Got a new starter solenoid which has y/r and g/r wires and two posts. Old one has y/r and blk. wires and two posts where heavier wires attach it to the battery and main harness. Can I attach new y/r to y/r in harness and g/r to blk in harness then attach heavier wires from the harness and battery to the same posts on the solenoid as the old one?
Jack
Re: Honda CB360 Solenoid
Posted: Sat Aug 12, 2017 1:08 am
by SCCB
Clipped off the old connecter and put new male and female bullet fittings on the new solenoid wires. Attached new y/r to y/r in harness and g/r to blk in harness then attached heavier wires from the harness and battery to the same posts on the solenoid as the old ones. Bike starts right up. Everything works fine.
Jack
Re: Honda CB360 Solenoid
Posted: Sat Aug 19, 2017 3:22 am
by NorthernPete
There you go. When all else fails give er. Lol.