Page 1 of 1
Need Kawasaki Electrical Help (igniter)
Posted: Sun Oct 30, 2005 12:24 pm
by adamodoyle
I have a 1983 Kawasaki KZ 250 LTD motorcycle engine I am wiring into a bike. I need to wire up the igniter, but don't have the original harness to work with. The igniter has a five prong plug; 12v, 2 for the Pickup, 2 to the coil
Arranged like this:
---
- -
Which one goes where????
it has electronic advance
Re: Need Kawasaki Electrical Help (igniter)
Posted: Sun Oct 30, 2005 6:28 pm
by flynrider
adamodoyle wrote:I have a 1982 Kawasaki KZ 250 LTD motorcycle engine I am wiring into a bike. I need to wire up the igniter, but don't have the original harness to work with. The igniter has a five prong plug; 12v, 2 for the Pickup, 2 to the coil
Arranged like this:
---
- -
Which one goes where????
it has electronic advance
Your best bet for KZ tech info will be over at KZRider.com. They've got a lot of KZ specific expertise over there.
Good luck with your FrankenBike. Looks like a unique project.
Posted: Mon Oct 31, 2005 2:38 pm
by adamodoyle
I've been there; nobody has had much info on the 250
The captions' not quite right- it's an '83
but here's my issue:
I should've gone with the Honda CB motor
Posted: Thu Nov 03, 2005 6:19 pm
by adamodoyle
I found my answers! I asked around again at the KZRider forum. It looks like there are a few new members there. Last time I was there, I got a lot of posts, asking if there was such a thing as a KZ 250.