stupid engine builder question :)

Message

mysta2 · #1 Unread post by **mysta2** » Fri Feb 03, 2006 9:56 am

where do you get those engine plugs to plug holes while you make a mess... I'm sick of taping over stuff

thanks

rhost · #2 Unread post by **rhost** » Fri Feb 03, 2006 10:39 am

http://www.plastem.com/

BuzZz · #3 Unread post by **BuzZz** » Fri Feb 03, 2006 10:22 pm

You could go down to the local hardware store and get an assortment of those pipe plugs they have in the pipe fittings department. If you get a friendly sales person you might be able to pick a few out of the bottom of a bin of fittings or something....

mysta2 · #4 Unread post by **mysta2** » Mon Feb 06, 2006 12:03 pm

rhost wrote:http://www.plastem.com/

wow... thanks. I wonder how many samples they'd be willing to float over to me.

kar_the_terrible · Sun Feb 19, 2006 7:30 am

so exacatly what rebuilding are you doing?

mysta2 · #6 Unread post by **mysta2** » Fri Feb 24, 2006 12:29 pm

mydlyfkryzis · Fri Feb 24, 2006 3:12 pm

REbuilding both 360's, or making 1 good one out of 2?

mysta2 · #8 Unread post by **mysta2** » Sun Feb 26, 2006 7:56 pm

both... hopefully, I know the one on the right's good... the one on the left is a mystery. It turns over though, so it's probably fine allthough it's missing a few essentials (like a generator)