I converted a Honda 5.5 Engine to a small 4 wheeler and now it will not pull it can someone help me with this. If you lift the bike up the wheels will turn but with any weight engine rev's and bike goes no where.
thanks Bob
Honda 5.5 Engine
-
BuzZz
- Site Supporter - Platinum
- Posts: 4726
- Joined: Sat Mar 20, 2004 12:02 am
- Real Name: Never Used Here
- Sex: Male
- Years Riding: 47
- My Motorcycle: makes my 'nads tingle
- Location: Buttfluck Nowhere, Manitoba
Sounds like it's geared way too high.
Whatever system you're using for final drive, the sprocket/pulley on the engine should be smaller diameter, or the sprocket/pulley on the axle should be larger diameter, or both.
That's the best I can come up with given the limited info supplied.
Good Luck.
Whatever system you're using for final drive, the sprocket/pulley on the engine should be smaller diameter, or the sprocket/pulley on the axle should be larger diameter, or both.
That's the best I can come up with given the limited info supplied.
Good Luck.
No Witnesses.... 
-
mydlyfkryzis
- Legendary 500
- Posts: 521
- Joined: Sun Jul 18, 2004 11:21 am
- Sex: Male
- Years Riding: 42
- My Motorcycle: 1976 CB360t, 1991 Honda Nighthawk 750
- Location: Northern NJ