Kill switch bad?

Message

ofblong · #1 Unread post by **ofblong** » Fri Apr 10, 2009 1:23 pm

Ok tonight I went to start my bike. I have been having problems lately that once in a while the bike will try to start but wont. well its been 2 weeks since I started it (sorry but in the 30's and raining isnt what I call a fun riding time as well as it just snowed 2 days ago). I flipped the switch to run and it wouldnt do anything. all the lights were on but it didnt even try to start. So I turned the switch off then back on and then it started just fine. I havent taken the assembly apart to look at the switch but is this a type of switch that could have some corrosion on it that can be cleaned off or is it most likely something im gonna have to replace? I am just afraid that riding down the road it might "quit" on me cause of the switch now that I know the one time it wouldnt start at first.

or is this something I can just jumper the wires together and not have to ever worry about it?

#2 Unread post by **Wrider** » Fri Apr 10, 2009 11:38 pm

Yeah it could just be a corroded switch or a loose wire. Pretty easy to take apart and fix or replace.

ofblong · #3 Unread post by **ofblong** » Sat Apr 11, 2009 9:34 am

well I took it apart and there wasnt any corrosion but there was ALOT of dirt in the contacts. so I cleaned it all up

.

Johnj · #4 Unread post by **Johnj** » Sat Apr 11, 2009 5:57 pm

Was it a lot of deer-gut dirt?

ofblong · #5 Unread post by **ofblong** » Sun Apr 12, 2009 1:13 am

Johnj wrote:Was it a lot of deer-gut dirt?

no it looked like it was mostly years of riding dirt even though the bike only has 24k miles on it. It was almost like dirty oil.