
I have an 07 Heritage and it came equipped with the factory alarm system. Here is my problem. I took on the task of swapping my handle bars with 16 inch Apes. I had to also replace all the cables and wire in the harness. Before starting the job, I disarmed the system. I also had the FOB in the vicinity of the bike. I figured I better disconnect the battery since I was doing wiring work. As soon as I disconnected the negative battery cable, the alarm started sounding. I played hell getting the @!#!!@ to shut off. Once I finished my project and got everything back together, I went to check out all my controls and I now have a dead bike. With the ignition switch off, the security light flickers as normal. When I turn the inition switch to IGN, the security light flashes about five times and then turns on steady. The horn and high beam work, the turn signals are dead, the run switch is dead, and the engine light does not illuminate at all.
I would have thought that somewhere in my owners manual it would have told me any specific procedures to follow when disconnecting the battery, but it does not.
I have rechecked all the wiring multiple times and it is wired correct.
HELP!!!
Dutch