Total Motorcycle Community Forums

The resistance is within spec on the pickup coil and the air gap between it and the rotor is within spec. I'm supposed to have 3.8volts for 5 seconds when cranking motor from p-up coil, I have none.

Could the rotor on the crank be bad?

Everything else on the bike tests out within spec.(Switches,fuses,coils,plug wires,etc.)

I doubt the rotor is bad, no experience with your particular bike, but rotors generally just spin and trigger the pick-up, if it is there, it should be working.

So that would point to the pick-up itself if everything else checks out. You may want to double check any ground straps/wires just to be sure....

The pickup coil assembly is new from Kawi. I replaced it because I got no voltage from the old one. They both read within spec on resistance.