cafe Mirrors

Message
Author
kar_the_terrible
Legendary
Legendary
Posts: 263
Joined: Wed Mar 16, 2005 6:35 am
Sex: Male
Location: Pittsburgh, PA

cafe Mirrors

#1 Unread post by kar_the_terrible »

So,
I got the clubman handlebars, removed the rear fender and fabbed a small tray to hold the license plate and a small taillight, so more of the rear tyre can be seen.
Now... the next thing to tackle are the mirrors. I still have the stock yamaha mirrors, but they dont really go with the handlbars :- too "vertical"

Ideally the end-mirror like what mysta2 has on his bike are good, but then I'd like mirrors on both sides, especially with the number of morons that sneak up and pass me on the right. Any suggestions/linx ??

I was thinking about cutting up the current mirror stalks, shortening them, and giving it more of an angle, so the mirrors are lower and swept back.
'78 Yamaha XS400
'86 Yamaha Radian

User avatar
Aggroton
Legendary 750
Legendary 750
Posts: 792
Joined: Wed May 18, 2005 3:57 am
Sex: Male
Location: Mechanicsburg Pa Represent

Re: cafe Mirrors

#2 Unread post by Aggroton »

kar_the_terrible wrote:So,


I was thinking about cutting up the current mirror stalks, shortening them, and giving it more of an angle, so the mirrors are lower and swept back.
that woould be sweet...and where did you get your clubmans from...and...

post some pics!
thats a sweet bike.

User avatar
Joe Mc
Elite
Elite
Posts: 186
Joined: Thu Jul 01, 2004 5:20 pm
Sex: Male
Location: Langley, B.C.

#3 Unread post by Joe Mc »

Yeah, post some pics!

I still haven't got my bars yet. Should be here early this week.

I have Napolean bar-end mirrors on my bike and they are awesome. Not only do they look better, but they work much better than stock. Instead of a view of my elbows, I can actually see beside and behind me! :o

They look better with just one, however, as the handle bars look really wide with two on. I put the right one on if I'm going to be on 4 lane highways.
'78 CB400T2 Hawk

kar_the_terrible
Legendary
Legendary
Posts: 263
Joined: Wed Mar 16, 2005 6:35 am
Sex: Male
Location: Pittsburgh, PA

#4 Unread post by kar_the_terrible »

I got them from mikesxs. While Im not going for the cafe racer look (still have my original side covers on, and the large turn signals), Im still getting rid of what I think is the antiquated look. Next is the seat that has to be dealt with..

I'll post pix soon, for opinions too :)
'78 Yamaha XS400
'86 Yamaha Radian

User avatar
mysta2
Legendary 300
Legendary 300
Posts: 361
Joined: Wed Mar 02, 2005 4:23 pm
Sex: Male
Location: Little Elm, TX.

#5 Unread post by mysta2 »

I got mine at my local Cycle Gear for somewhere around $12, and I got what I paid for. it's a bit distorted but it doesn't actually matter since it vibrates so much. Yeah a right side would be nice... I just couldn't bring myself to do that to my bike.
[url=http://www.cafepress.com/dropbars][img]http://www.dropbars.com/cafepress%20banner.jpg[/img][/url]
Check out my [url=http://www.totalmotorcycle.com/BBS/viewtopic.php?t=5844]blog[/url] for the latest on my little project.

User avatar
Wizzard
Legendary 1000
Legendary 1000
Posts: 1471
Joined: Tue Jun 28, 2005 12:56 am
Sex: Male
Location: Fresno, California

#6 Unread post by Wizzard »

No insult intended here , but please do not make the same mistake I made on my Yamaha Virago , remember that the right hand mirror has reversed threads . I sheared mine off . Now my brother-in-law owns the bike and has to get a reverse easy out to fix it ......... :roll: Oops.......... :laughing:
Kind regards, Wizzard
"Life is not a journey to the grave with the intention of arriving safely in a pretty and well preserved body, but rather to skid in broadside, throughly used up, totally worn out, and loudly proclaiming --- ' WOW, WHAT A RIDE!!!! ' " - Author Unknown

User avatar
ZooTech
Legendary 3000
Legendary 3000
Posts: 3233
Joined: Mon Jun 13, 2005 3:23 am
Sex: Male
Years Riding: 18
My Motorcycle: Nomad / Ninja 500 / VLX Bobber / C3 / VS
Location: Ohio

#7 Unread post by ZooTech »

Wizzard wrote:remember that the right hand mirror has reversed threads
Wouldn't that be the left mirror (as viewed while sitting on the bike)? If the right hand mirror had traditional threads, and the left reversed...the wind would blow each mirror tighter...which is the point.

Incidentally, a Dremel with a cutting disc installed will easily slot the end of the mirror shaft so he can back it out with a flat-head screwdriver. Unless, of course, it sheared-off flush or countersunk.

kar_the_terrible
Legendary
Legendary
Posts: 263
Joined: Wed Mar 16, 2005 6:35 am
Sex: Male
Location: Pittsburgh, PA

#8 Unread post by kar_the_terrible »

Aye I know! But I doubt that would make a difference for bar-end mirrors.

FYI, there is a bar end mirror intended for bicycles c alled third eye. however... they are constructed to have the same field of view angle as automotive mirrors. made out of glass with a reflective aluminiized backing. 3in diameter

apparently a few sport bike guys have put them on theier bikes and are quite happy about it. they seem to look OK mounted on both sides, and are compact enough not to give the mickey mouse effect. I'll go a round some bike shops and check them out. They're about the same as a lot of bar end mirrors about $12 apiece.

Here's a link of guy who put it onto his ducati
http://ccrma.stanford.edu/~peer/Duc/duc ... rrors.html

FYI.
'78 Yamaha XS400
'86 Yamaha Radian

User avatar
Joe Mc
Elite
Elite
Posts: 186
Joined: Thu Jul 01, 2004 5:20 pm
Sex: Male
Location: Langley, B.C.

#9 Unread post by Joe Mc »

Those mirrors look pretty cool. The only problem I see is that they are so low that you'd have to move your head quite a bit to use them. Probably worth the $12 to try them though.

The Napolean mirrors I have were $29 Us ea. but well worth it. The quality is good and they are rubber mounted. They also have detents and swing out of the way for narrow spaces.

How does the riding position feel with the new bars?
'78 CB400T2 Hawk

kar_the_terrible
Legendary
Legendary
Posts: 263
Joined: Wed Mar 16, 2005 6:35 am
Sex: Male
Location: Pittsburgh, PA

#10 Unread post by kar_the_terrible »

new bars are pretty good. its quite comfortable, I commute everyday on my bike, with a backpack, after 4 days I have no complaints yet. I still have the stock seat though, dont knwo if thata makes a difference or not.
'78 Yamaha XS400
'86 Yamaha Radian

Post Reply