Push rod not moving

Message

Reford · #1 Unread post by **Reford** » Sun Jul 08, 2012 4:50 pm

Hi Riders,
I have been riding bikes for over 20 years, I have recently come across an 82 Honda CB900C, I am in the process of making a bobber. I am having Clutch problems, the Push Rod will not move. I can tell that someone has tried to do some work on it because the screws were loose on the case and the seal was new. When I pull in the clutch it does not move the push rod. I have checked the Cable and that is not the issue. Does anyone have any ideas?
Thanks
Rford

#2 Unread post by **Wrider** » Sun Jul 08, 2012 10:03 pm

Chances are that the pushrod itself is seized into the housing.

I don't know that specific bike, but if you can, get on the back side of it and use some compressed air/hydraulic pressure to break it loose.

Reford · #3 Unread post by **Reford** » Mon Jul 09, 2012 3:50 am

I will try that, and let you know how it goes, It will be a few days before I can work on the bike again.

Thanks.

Reford · #4 Unread post by **Reford** » Tue Jul 31, 2012 5:39 am

The Clutch problem is solved, thats for all the help, you guys are great, on to the next step, fixing the seal on my front folks.

Reford · #5 Unread post by **Reford** » Tue Jul 31, 2012 5:42 am

Forks,

sorry,

lol

Tue Jul 31, 2012 9:12 am

...and Reford, can you share how you solved/fixed it for others here?

Mike

#7 Unread post by **Wrider** » Tue Jul 31, 2012 10:27 am

That'd be very helpful! And no problem.

Total Motorcycle Community Forums

Push rod not moving

Push rod not moving

Re: Push rod not moving

Re: Push rod not moving

Re: Push rod not moving

Re: Push rod not moving

Re: Push rod not moving

Re: Push rod not moving