Need help in Diagnostics Lights on 1965 M12 motor Cycle

Message

Panther · #1 Unread post by **Panther** » Sat Mar 23, 2013 1:30 pm

Please help point me in the right direction, My M12 Suzuki Motor cycle runs good , But all the lights stopped working I herd a pop like a fuse blowing, although there are no fuses on this bike, Is it the selenium rectifier that controls the power to the lights?

Johnj · #2 Unread post by **Johnj** » Sun Mar 24, 2013 4:42 am

Do you have a volt - ohm meter or DVM that you can read the voltage with?

Panther · #3 Unread post by **Panther** » Sun Mar 24, 2013 7:24 am

Yes I have a Ohms/volt meter just not sure at what points I need to test, I believe the system is 6 Volt as that is what the bulds are rated for.
Brian

Panther · #4 Unread post by **Panther** » Sun Mar 24, 2013 7:30 am

I have checked for continuity through the coil to the magneto pads to the attached wiring and I have continuity

Johnj · #5 Unread post by **Johnj** » Sun Mar 24, 2013 6:02 pm

OK set the meter for voltage and set the voltage above 12 volts. Now read how many volts you have across the headlight (while the bike is running).

Do you have a manual for the bike?

Total Motorcycle Community Forums

Need help in Diagnostics Lights on 1965 M12 motor Cycle

Need help in Diagnostics Lights on 1965 M12 motor Cycle

Re: Need help in Diagnostics Lights on 1965 M12 motor Cycle

Re: Need help in Diagnostics Lights on 1965 M12 motor Cycle

Re: Need help in Diagnostics Lights on 1965 M12 motor Cycle

Re: Need help in Diagnostics Lights on 1965 M12 motor Cycle