License frame for Maryland plate

Message

Ham Hock · #1 Unread post by **Ham Hock** » Mon Aug 29, 2005 2:34 am

Does anyone have a recommendation for a license plate frame for Maryland plates? I have been looking on various sites and notice there are MD specific frames (along with a few other states). The mounting hardware that I currently have is looking pretty bad.

I am looking for something simple and cheap with no lights.

Why are frames so expensive, $30+ for a square piece of metal?

mattf · #2 Unread post by **mattf** » Tue Sep 06, 2005 7:20 am

Maryland plates are a PITA. They are larger than any other state that I know of (obviously you know that, but not everyone else does). Good luck finding a frame. I just go without.

#3 Unread post by **dr_bar** » Tue Sep 06, 2005 9:24 am

You could look for a machine shop that has a "CNC Milling Machine" and get them to "one off" you a frame out of billet aluminum. It will probably be a bit costly but can be done in a very short time... A lot of custom shops have them for custom parts...

Ham Hock · #4 Unread post by **Ham Hock** » Tue Sep 06, 2005 11:27 am

Yep I'll just do without a frame. I did find a billet aluminum frame, but I do not want one bad enough to spend $80 on it.